Tie Line Answer Detect Time Selection 1 - 275
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
3-17
System Mode
3
Submode
—
Data No.
17
PC Programming
a
+ALM
Tie Line Answer Detect Time
Selection
General Description
Use this Memory Block to specify the duration between the time when the receiving Xen
system answers (off-hook) and the time when it is recognized as an answer.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3
LK 4
The shaded area indicates the default setting.
0 ms. 130 ms. 260 ms. 390 ms.
LK 5 LK 6 LK 7 LK 8
520 ms. 650 ms. 780 ms. 910 ms.
(Page 2)
LK 1LK 2LK 3LK 4
1040 ms. 1170 ms. 1300 ms. 1430 ms.
LK 5 LK 6 LK 7 LK 8
1560 ms. 1690 ms. 1820 ms. 1950 ms.
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + AG to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: The following are used when entering data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Answering a call may not be possible if the CO answer detect time is too long.
0 1 / 1 7 : P R E 3 9 0 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
Page
No.
To Next Page
Loading...
