1 - 212 PC Programming Password Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-8-17
System Mode
1
Submode
8
Data No.
17
PC Programming
a
+CSP
PC Programming Password
Assignment
General Description
Use this Memory Block to set a system password that must be entered when using PC
Programming.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
AGto access the Memory Block.
3 Use the following to enter Class 1(Technician Mode) and password (8 dig
its max):
Note: Use the following to enter data:
K~Ito enter numeric data
Press
Uto clear data
Default Values
Class 1 Blank
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Programming from a Multiline Terminal allows eight digits to be entered for each class.
2. PC Programming allows only five digits to be entered; if more are entered, a “Password No Good” error is provided
when a login is attempted.
1 7 : ( 1 ) =
T I M E D I S P L A Y
Data
No.
Setting
Data
Class
No. 1
To Next Page
Loading...
Need help?
General
