NEC Xen Master - 1-4-05 Automatic Tandem Trunk by Night Mode Selection

Automatic Tandem Trunk by Night Mode Selection 1 - 153
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-4-05
System Mode
1
Submode
4
Data No.
05
PC Programming
a
+AT
Automatic Tandem Trunk by Night
Mode Selection
General Description
This Memory Block is used to establish whether or not the Automatic Trunk-to-Trunk
Transfer feature follows the Night Mode assignment.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
KE to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-27
Automatic Day/Night Mode Switching Time Assignment
1-1-33
Speed Dial Number/Name Display Selection
3-05
Trunk Incoming Answer Mode Selection
3-06
Automatic Tandem Trunk Assignment
0 5 : T A N D B Y N T N O
T I M E D I S P L A Y
Data
No. Title
Setting
Data