DID Digit Conversion Assignment 1 - 49
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-1-21
System Mode
1
Submode
1
Data No.
21
PC Programming
a
+ALN
DID Digit Conversion Assignment
General Description
Use this Memory Block to enable the DID Digit Conversion Table & DNIS Assignment,
Memory Block 1-1-22, for each number. If No is assigned here, only Memory Block 5-00
has an impact on incoming DID numbers. If Yes is assigned here, incoming DID numbers
can be modified completely for each number.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
No Yes
LK 5
LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BA to access the Memory Block.
3 Enter the data using the Line key. Default Values
NO
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-20
DID Digit Length Selection
1-1-22
DID Digit Conversion Table & DNIS Assignment
1-1-23
DID Forward Station Number for Undefined Digit
2 1 : D I D C N V Y S
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
Need help?
General
