NEC Xen Master - 1-4-11 Automated Attendant Message Day; Night Mode Selection

1 - 156 Automated Attendant Message Day/Night Mode Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
1-4-11
System Mode
1
Submode
4
Data No.
11
PC Programming
a
+AU
Automated Attendant Message Day/
Night Mode Selection
General Description
Use this Memory Block to specify Automated Attendant messages that are available for use
in a Day/Night Mode setting.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Yes No
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
AA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Use the dial pad to enter A.A. message number.
Note: Use the following to enter data:
A~Hto enter numerical data
Qto toggle between Day Mode and Night Mode
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
1. This Memory Block must be set to YES for Automated Attendant to be enabled.
1 1 : A A M S G 1 ( D Y ) = N O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A. Msg.
No.
1~8
Day/Night
Mode