NEC Xen Master - 3-06 Automatic Tandem Trunk Assignment

1 - 268 Automatic Tandem Trunk Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
3-06
System Mode
3
Submode
—
Data No.
06
PC Programming
a
+AT
Automatic Tandem Trunk
Assignment
General Description
Use this Memory Block to specify the incoming trunk and outgoing trunk for Automatic
Trunk-to-Trunk Transfer.
Display
Programming Procedures
1 Go off-line.
2 Press LK3 +N+ KFto access the Memory Block.
3 Enter data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to go to the next CO/PBX Line No.
Default Values
Not Specified
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-04
Trunk-to-Trunk Transfer Yes/No Selection
0 1 / 0 6 : T A N D C O =
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
(Incoming)
CO/PBX
No.
(01~64)