NEC Xen Master - 1-1-24 PBX;CTX Access Code Assignment I

PBX/CTX Access Code Assignment I 1 - 53
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-24
System Mode
1
Submode
1
Data No.
24
PC Programming
a
+BA
PBX/CTX Access Code Assignment I
General Description
Use this Memory Block to specify a PBX line PBX/CTX Access Code together with pauses
for outgoing calls.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BD to access the Memory Block.
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Q to insert a pause
U to clear all data
Default Values
0-
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-90
Trunk Type Selection
N
1. Features such as Code Restriction do not operate properly unless a PBX/CTX Access Code is specified. This
limitation applies to PBX lines assigned in Memory Block 3-90 Trunk Type Selection.
2. A pause is not inserted in the number of an outgoing call on a CO line.
3. Up to three numeric characters and three pauses can be specified.
4. A pause cannot be inserted as the first digit or as consecutive digits.
5. A -(dash) is the entry for pause.
2 4 : P B X A C 0
T I M E D I S P L A Y
Data
No. Title
Setting
Data
Example:

Xen
System
Xen System
Intercom Line
PBX Line
PBX
CO Line