Trunk Queuing Timeout Selection 1 - 67
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-1-37
System Mode
1
Submode
1
Data No.
37
PC Programming
a
+BM
Trunk Queuing Timeout Selection
General Description
Use this Memory Block to specify the time that a station with Trunk Queue set rings, before
the queue is automatically canceled.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
10 sec. 20 sec. 30 sec. 60 sec.
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
CGto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
When all trunks in a particular Trunk Group are busy, the station user can dial an Access Code to queue on the busy
Trunk Group. When a Trunk (in that group) becomes idle, the queued station is signalled.
3 7 : T R U N K Q U E 1 0 s
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
Need help?
General
