NEC Xen Master - 3-90 Polarity Reverse Selection

1 - 318 Polarity Reverse Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
3-90
System Mode
3
Submode
—
Data No.
90
PC Programming
a
+BCT
Polarity Reverse Selection
General Description
In some cases a Central Office may provide a line reversed to provide a disconnect signal.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + IK to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. BRI and PRI lines are to be set to YES at all times.
1 1 / 9 0 : R V R S ( Y S )
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting Data
(20 digits maximum)