1 - 98 8-Digit Matching Table to Normal Dial Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-1-66
System Mode
1
Submode
1
Data No.
66
PC Programming
a
+AC
8-Digit Matching Table to Normal
Dial Assignment
General Description
Use this Memory Block to assign the 8-Digit Matching Table by class for normal dialling as
used or unused. If unused is assigned, the system does not check during normal dialling
even if Memory Block 1-1-61 8-Digit Matching Table to Class Assignment is programmed.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
There is no default setting.
Table 00 Table 01 Table 02 Table 03
LK 5 LK 6 LK 7 LK 8
Table 04 Table 05 Table 06 Table 07
(Page 2)
LK 1 LK 2 LK 3 LK 4
Table 08 Table 09 Table 10 Table 11
LK 5 LK 6 LK 7 LK 8
Table 12 Table 13 Table 14 Table 15
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + FF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Note: Use the following to enter data:
Sto access the next page.
Tto access the previous page.
Each time a CO/PBX line key is pressed, the LED toggles between On
and Off.
Default Values
Tables 00~15 Used
4 Press
Nto write the data and advance to the next class. Repeat steps 3 and 4 until last class is assigned.
5 Press
Nto write the last data.
6 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Section 6 Code Restriction in this chapter.
6 6 : N O R M A L D I A L | 1
T I M E D I S P L A Y
a
a
No.
e
ng
Data
Title
CO/PBX
Line LED
Off On
Data Restricted Not restricted
There is no default setting.
To Next Page
Loading...
Need help?
General
