1 - 50 DID Digit Conversion Table & DNIS Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-1-22
System Mode
1
Submode
1
Data No.
22
PC Programming
a
+ALN
DID Digit Conversion Table & DNIS
Assignment
General Description
Up to 200 incoming DID numbers can be assigned individually to ring at preassigned
extension numbers on a day mode and night mode basis. This Memory Block applies to the
DID number after it is modified by Memory Block 5-00.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
TEL=T
TENANT=TN
(v2.xx or higher)
LK 5 LK 6 LK 7 LK 8
Note: Version 1.xx and 2.xx shows the time in DNIS assignment area.
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + BB to access the Memory Block.
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
S to change DNIS, then use K~I to enter an alphanumeric name for
each indial number (name applies to both day and night mode). Refer to Table 1-
7, “System Data Input,” on page 444 for details on character entry.
Q to change between Day and Night table
U to clear all data
Default Values
Setting Data
TEL = LK1 = Extension No.00~99
000~999
0000~9999
TENANT = LK2 = 00~47
4 Press
Nto write the data.
5 Press
Pto go back on-line.
2 2 : D Y = T
Data
No.
Digits
Received Title Destination
DNIS ASSIGNMENT
To Next Page
Loading...
Need help?
General
