NEC Xen Master - 4-62 ISDN Extension-based Caller ID Assignment

1 - 380 ISDN Extension-based Caller ID Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
4-62
System Mode
4
Submode
—
Data No.
62
PC Programming
a
+BTT
ISDN Extension-based Caller ID
Assignment
General Description
This Memory Block provides the station DID Number (CPN, Calling Party Number) to the
Network when placing outgoing calls.
System Software version 5.0 or higher is required.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
FB to access the Memory Block.
3 Use the following to enter data:
Jto move the cursor left.
Lto move the cursor right.
K~Ito enter numeric data.
– OR –
Press
Rto go to the next TEL port number.
Press
Uto clear data.
4 Press
Nto write the data and display Memory Block 4-01.
5 Program Memory Block 4-01 or press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-52 ISDN Trunk Directory Number Assignment
3-90 Trunk Type Selection
4-47 ISDN Directory Number Selection
N
1. A maximum of 13 digits is allowed.
2. Hyphens/dashes are not allowed when entering the directory number.
3. This Memory Block supports only trunks assigned as DID in Memory Block 3-90.
4. When using CO Line Mode, Memory Block 3-52 is used to assign the directory number of ISDN.
0 1 / 6 2 :
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~CO)
Setting
Data