1 - 64 Tie Line First Ring Pattern Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-1-34
System Mode
1
Submode
1
Data No.
34
PC Programming
a
+ALN
Tie Line First Ring Pattern Selection
General Description
Use this Memory Block to set specific ringing tones for incoming calls on Tie lines. After a
delay interval specified in Memory Block 1-1-07
Tie Line Delay Ringing Timer Selection, a Tie
call can ring at all Day/Night ring-assigned telephones using a different cadence.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Pattern 1 Pattern 2 Pattern 3 Pattern 4
LK 5 LK 6 LK 7 LK 8
ICM Voice
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
CDto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-07
Tie Line Delay Ringing Timer Selection
1-1-53
Tie Line Delay Ring Pattern Selection
4-01
CO/PBX Ring Assignment (Day Mode)
4-02
CO/PBX Ring Assignment (Night Mode)
N
1. Specify one pattern in the Ringing Pattern Selection Table.
2. If Voice is selected, switching from voice to tone is not allowed, Memory Block 1-1-07 is not used, and Handsfree
Answerback is not allowed at the receiving station.
3 4 : T L I R N G P A T 3
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
