DIT Night Mode Delay Answer Enable 1 - 311
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
3-64
System Mode
3
Submode
—
Data No.
64
PC Programming
a
+BCT
DIT Night Mode Delay Answer
Enable
General Description
This Memory Block is used to specify whether or not the DIT Delay Answer Timer shall
apply to CO/PBX calls received when the system is in Night Mode.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + DDto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
Rto go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-61
DIT Delay Answer Timer Selection
N
1. The DIT Delay Answer Time specified in MB 3-61 shall apply for this purpose.
2. If set to YES, incoming CO/PBX calls during Night Mode will ring for the duration specified in MB 3-61 before
changing to DIT status.
3. If set to NO, incoming CO/PBX calls during Night Mode will immediately change to DIT status regardless of the setting
in MB 3-45.
4. This setting only applies to those CO/PBX lines assigned with the DIT facility in MB 3-42 and MB 3-43.
1 1 / 6 4 : N T M O D N 0
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
To Next Page
Loading...
Need help?
General
