NEC Xen Master - 1-1-51 CO Line Ringing Pattern Selection

CO Line Ringing Pattern Selection 1 - 79
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-51
System Mode
1
Submode
1
Data No.
51
PC Programming
a
+BCS
CO Line Ringing Pattern Selection
General Description
Use this Memory Block to assign the initial ringing pattern for incoming calls on a CO line.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
Ring Pattern
A
Ring Pattern
B
Ring Pattern
C
Ring Pattern
D
LK 5 LK 6
LK 7 LK 8
Ring Pattern
E
Ring Pattern
F
Ring Pattern
G
Ring Pattern
H
LK 9 LK 10 LK 11 LK 12
No ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
EA to access the Memory Block.
3 Press corresponding CO/PBX line key to change data.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page
4 Press
Nto write data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-59
Synchronous Ringing Selection
5 1 : C O P T N G | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.