NEC Xen Master - 3-72 ISDN BRT Connection Configuration

DIT Night Mode Delay Answer Enable 1 - 317
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
3-72
System Mode
3
Submode
—
Data No.
72
PC Programming
a
+AN
ISDN BRT Connection Configuration
General Description
Use this Memory Block to specify the type of Basic Rate ISDN Connection configuration
required.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
P-MP P-P
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + GBto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
Rto go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
N
1. P-MP = Point to Multipoint
P-P = Point to Point
0 1 / 7 2 : C O N N P - M P
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data