1 - 384 Telephone Ringing Variation Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
4-91
System Mode
4
Submode
—
Data No.
91
PC Programming
a
+BTM
Telephone Ringing Variation
Selection
General Description
Use this Memory Block to assign a Low, Medium, or High ringing tone frequency if
Telephone is specified in Memory Block 1-1-28 Distinctive Ringing by Telephone or CO
Selection.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Medium Low High
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK4 +
IA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Use the following to change option:
R select next Tel Port No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-28
Distinctive Ringing by Telephone or CO Selection
N
1. This block is applicable for telephones selected in Memory Block 1-1-28 Distinctive Ringing by Telephone or CO
Selection.
2. Selected ringing tone (H, M or L) follows when transferring calls.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 9 1 : R N G T O N E = M
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data
To Next Page
Loading...
