Trunk Digit Restriction 1 - 353
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
4-32
System Mode
4
Submode
—
Data No.
32
PC Programming
a
+BTT
Trunk Digit Restriction
General Description
Use this Memory Block to specify the maximum number of digits per station that can be
dialled while on any outside line.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
CB to access the Memory Block.
3 Use the dial pad to enter Setting Data (00 ~ 99 digits).
Note: Use the following to enter data:
K~I to enter numeric data
Rto select next Tel Port No.
Default Values
00 (No Limit)
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Section 6 Code Restriction in this chapter.
N
1. Code Restriction must be assigned before this feature is used.
2. Trunk Digit Restriction applies to all CO/PBX lines.
3. Tie Line Code Restriction must be assigned before this feature works on Tie lines.
4. Telephone ports A0~C0 are ports 100~120.
0 1 / 3 2 : D G R E S T = 0 0
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Setting
Data
Title
To Next Page
Loading...
Need help?
General
