NEC Xen Master - 1-4-21 Automated Attendant Extension Number Assignment

Automated Attendant Extension Number Assignment 1 - 167
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-4-21
System Mode
1
Submode
4
Data No.
21
PC Programming
a
+AU
Automated Attendant Extension
Number Assignment
General Description
Use this Memory Block to assign the extension number of each AA message.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
BAto access the Memory Block.
3 Use the dial pad to enter data.
Note: Use the following to enter data:
A~H to enter Automated Attendant message number
KK~II,
KKK~III,
KKKK~IIII
(Depends what length the extension number has been assigned in HB1-2-03.)
Default Values
Not assigned.
4 Press
Nto write the data, and advance to the next A.A.No.
5 After the last entry, press
Nto write the data.
6 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
1. Extension number should not be the same as the physical extension, CAR, ACD/UCD/SCD pilot number.
2. This memory block is applicable to main software Release 4.0 and above.
2 1 : A A M S G 1 =
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A. Msg.
No.
1~8