ACR Feature Allow/Deny Selection 1 - 243
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-14-00
System Mode
1
Submode
14
Data No.
00
PC Programming
a
+AO
ACR Feature Allow/Deny Selection
General Description
Use this Memory Block to specify whether or not ACR is system wide.
This feature requires System Software V3.XX or higher.
*When ACR is set to Allow in this MB, LCR stored on the MIF-L will stop functioning.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded selection is the default.
NO
(Deny)
YES
(Allow)
LK 5LK 6LK 7LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK14 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
4-41
LCR Class Selection
1-8-08
Class of Service (Station) Feature Selection 2
1-14-01
ACR Dialling Assignment
1-14-01
ACR Dialled Number Dial Allow/Deny Selection
1-14-03
ACR Trunk Group to Route Number Assignment
1-14-05
ACR Digit Add Assignment
1-14-02
ACR Route Table Number Assignment
1-14-04
ACR Digit Delete Assignment
0 0 : A C R N O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
To Next Page
Loading...
Need help?
General
