NEC Xen Master Programming Manual

Automated Attendant Transfer Ring Pattern 1 - 85
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-1-54
System Mode
1
Submode
1
Data No.
54
PC Programming
a
+AU
Automated Attendant Transfer Ring
Pattern
General Description
Use this Memory Block to specify the ringing pattern sent to the Multiline Terminal when an
incoming call is received at the Automated Attendant and transferred.
Display
Settings
(Page 1)
LK 1 LK 2
LK 3 LK 4
Ring Pattern
A
Ring Pattern
B
Ring Pattern
C
Ring Pattern
D
LK 5 LK 6 LK 7 LK 8
Ring Pattern
E
Ring Pattern
F
Ring Pattern
G
Ring Pattern
H
(Page 2)
The shaded area indicates the default setting.
LK 9 LK 10 LK 11 LK 12
No Ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
ED to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming.
5 4 : A A P T N C | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.

NEC Xen Master Specifications

General

Brand	NEC
Model	Xen Master
Category	Telephone
Language	English