Automated Attendant PBR Start Time Selection 1 - 155
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-4-09
System Mode
1
Submode
4
Data No.
09
PC Programming
a
+AU
Automated Attendant PBR Start
Time Selection
General Description
This Memory Block is used to specify whether the Push Button Receiver (PBR) can receive
dual-tone multifrequency (DTMF) signaling while the Automated Attendant is sending the
message or after the message is complete.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
FR AF
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK4 + KI to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Setting Data:
FR: While the Automated Attendant sends the message.
AF: After the Automated Attendant sends the message.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
When FR is assigned, the Automated Attendant message send start time and the PBR connected to Automated
Attendant trunk start time are the same.
0 9 : P B R S T R T F R
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
