1 - 300 DIT Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
3-42
System Mode
3
Submode
—
Data No.
42
PC Programming
a
+BCT
DIT Assignment
General Description
Use this Memory Block to independently assign a Day Mode direct trunk termination to a
station.
Display
Programming Procedures
1 Go off-line.
2 Press LK3 +
N+ DBto access the Memory Block.
3 Enter data using the dial pad.
Note: Use the following to enter data:
K~I to enter the numeric data
R to go to the next CO/PBX Line No.
Enter the following:
Station No. (2-, 3-, or 4-digits 00~9999)
CO Port No. (01~64)
Default Values
No Assignment
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-43
ANA Assignment
N
No related programming is necessary for this Memory Block.A trunk can terminate at only one station, but
any number of trunks can terminate at the same station.
0 1 / 4 2 : D I T D =
T I M E D I S P L A Y
Data
No.
Setting Data
Station No.
(2-digit: 00~99)
(3-digit: 000~999)
(4-digit: 0000~9999)
(Incoming)
CO/PBX
No.
(01~64)
Title
To Next Page
Loading...
