ISDN Directory Number Selection 1 - 367
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
4-47
System Mode
4
Submode
—
Data No.
47
PC Programming
a
+AN
ISDN Directory Number Selection
General Description
This Memory Block specifies whether or not the directory Number is presented to the
Network when a call is placed from the programmed station.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
Yes No
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK4 +
DG to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
Nto write the data and display the next Memory Block.
5 Program the next Memory Block or press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-52
ISDN Trunk Directory Number Assignment
3-90
Trunk Type Selection
4-62
ISDN Extension-based Caller ID Assignment
N
1. When this Memory Block is set to No, and ISDN is used in CO Mode in Memory Block 3-90, the programmed number
in Memory Block 3-52 is not presented as Caller ID. The Network presents Restricted for the Caller ID information.
2. When this Memory Block is set to YES and ISDN is used in CO Mode in Memory Block 3-90, the programmed
number in Memory Block 3-52 is presented as Caller ID. The Network presents the programmed number as
Caller ID.
3. When this Memory Block is set to No and ISDN is used in DID Mode in Memory block 3-90, the programmed number
in Memory Block 3-52 is not presented as Caller ID. System Software version 5.0 or higher is required.
4. When this Memory Block is set to YES and ISDN is used in DID Mode in Memory Block 3-90, the programmed
number in Memory Block 4-62 is presented as Caller ID. The Network presents the programmed number as Caller
ID. System Software version 5.0 or higher is required.
0 1 / 4 7 : C – I D Y E S
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~CO)
Title
Setting
Data
To Next Page
Loading...
Need help?
General
