1 - 152 Tandem Transfer SMDR Print Extension Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-4-04
System Mode
1
Submode
4
Data No.
04
PC Programming
a
+AT
Tandem Transfer SMDR Print
Extension Assignment
General Description
Use this Memory Block to specify a special number to be output from Station Message
Detail Recording (SMDR) to indicate an automatic Trunk-to-Trunk transfer.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK4 + KD to access the Memory Block.
3 Use the dial pad to enter the Table Number and Setting Data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
Setting Data Allowed
2-Digit Number:00~99
3-Digit Number:000~999
4-Digit Number:0000~9999
Default Values
3-digit number = 999
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-2-03
2-, 3-, or 4-Digit Station Number Selection
N
1. When the system is powered up initially, this block defaults to 3-digit number 999.
2. If 2-digit station numbers are selected, this block defaults to 99.
3. If 4-digit station numbers are selected, this block defaults to 9999.
0 4 : T A N D E X T = 9 9 9
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
Need help?
General
