1 - 148 Automated Attendant First Digit PBR Release Timer Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-4-01
System Mode
1
Submode
4
Data No.
01
PC Programming
a
+AU
Automated Attendant First Digit
PBR Release Timer Selection
General Description
Use this Memory Block to specify the time a Push Button Receiver (PBR) circuit remains
connected after the Automated Attendant message is played when a calling party calls in
through an Automated Attendant trunk.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
5 sec. 10 sec. 20 sec. 30 sec.
LK 5 LK 6 LK 7 LK 8
40 sec. 50 sec. 60 sec.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4
+KAto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
After PBR is connected, dialling must be completed in the specified time. After the first digit is dialled, interdigit timing
(default 7 sec.) controls the PBR timer. Dialing the third digit exceeds the 20 sec. default, and the PBR is disconnected.
0 1 : A A P B R T I M E 2 0 s
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
