NEC Xen Master - 1-4-12 Automated Attendant Message to Tenant Assignment

Automated Attendant Message to Tenant Assignment 1 - 157
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-4-12
System Mode
1
Submode
4
Data No.
12
PC Programming
a
+AU
Automated Attendant Message to
Tenant
Assignment
General Description
Use this Memory Block to assign Automated Attendant Messages to Tenant.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
ABto access the Memory Block.
3 Use the dial pad to enter data.
Note: Use the following to enter data:
A~H to enter Automated Attendant message number.
K~I to enter Tenant Number.
Default Values
All Automated Attendant Messages:
Tenant No. 00
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
N
If a tenant is not assigned to a specific automated message, the Automated Attendant sends the message assigned in
Memory Block 1-4-11 Automated Attendant Message Day/Night Mode Selection.
1 2 : A A 1 T N A T = 0 0
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
A.A.
No.
1~8