NEC Xen Master - 4-57 CO Line Ringing Pattern by Telephone or CO Selection

1 - 376 CO Line Ringing Pattern by Telephone or CO Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
4-57
System Mode
4
Submode
—
Data No.
57
PC Programming
a
+BTT
CO Line Ringing Pattern by
Telephone or CO Selection
General Description
Use this memory block to select if CO or Telephone is to have ring pattern.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
CO Telephone
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK4 +
EG to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option
Note: Use the following to change option:
Rto move to the next Tel Port No.
Default Values
:
CO
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-67
CO Line Ringing Pattern Selection for CO/PBX Line Mode
4-53
CO Ringing Pattern Selection for Telephone Mode
N
1. This memory block is applicable for main software Release 4.0 and above.
0 1 / 5 7 : R N G P R I C O
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title