EasyManuals Logo

NEC Xen Master Programming Manual

NEC Xen Master
536 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #437 background imageLoading...
Page #437 background image
Second Initialisation 1 - 419
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
8-8-8800
System Mode
8
CO-Line
8
Data No.
8800
PC Programming
a
+CI
Second Initialisation
General Description
Use this Memory Block to initialize all the system hardware. All system software and user
programming are retained after the Second Initialization.
Note: IMPORTANT
If VMS, FMS, ACD and/or IPT cards installed in the system, please ensure all cards have
completed their startup sequence before performing a second initialisation.
These cards are considered fully ‘started up’ about 5 minutes after power is applied.
Display
Programming Procedures
1 Go off-line.
2 Press LK8 + LK8 +
HHKK to access the Memory Block.
3 When the system display prompt indicates CPU RESET?, the first four CO/PBX lines light red.
4 Press
Nto begin the initialization process.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
C P U R E S E T ?
T I M E D I S P L A Y
WWWW
Red Red Red Red

Table of Contents

Other manuals for NEC Xen Master

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC Xen Master and is the answer not in the manual?

NEC Xen Master Specifications

General IconGeneral
BrandNEC
ModelXen Master
CategoryTelephone
LanguageEnglish

Related product manuals