1 - 230 DISA/ID Password Effect/Invalid Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-9-02
System Mode
1
Submode
9
Data No.
02
PC Programming
a
+BD
DISA/ID Password Effect/Invalid
Selection
General Description
Use this Memory Block to assign a Direct Inward System Access (DISA) Password as
Invalid (LK1) or Effective (LD2). If invalid is assigned, the calling party can use the DISA
feature without a DISA Password.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK9 +
KB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Setting Data:
NO (LK1) = DISA Password Invalid (Password is not required).
YES (LK2) = DISA Password in Effect (Password is required. Assign with MB 1-1-46~ 1-1-48).
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to access the next ID buffer number
Q+1, 2, 3 = A, B, or C for Port Number
ID Buffer Number:
01~99 = 01~99
A0~A9 = 100~109
B0~B9 = 110~119
C0 = 120
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming.
0 1 / 0 2 : P A S W O R D = Y S
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
ID Buffer No.
(01~C0)
To Next Page
Loading...
Need help?
General
