1 - 368 Caller ID Display for CAR Key
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
4-50
System Mode
4
Submode
—
Data No.
49
PC Programming
a
+AI
Caller ID Display for CAR Key
General Description
This Memory Block assigns one Multiline Terminal per CAR to display Caller ID Indication
on incoming CAR calls.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK10 +
KF to access the Memory Block.
3 Use the dial pad to enter Setting Data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to select next CAR No.
Default Values
Not Specified
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
To display Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID Indication and Ring
assignment must be assigned for the terminal in System Programming. A maximum of 15 Multiline Terminals can be
assigned system-wide to display caller identification for normal incoming CO calls and CAR incoming calls using Memory
Block 1-1-78 Caller ID Display Assignment for System Mode. A sixteenth Multiline Terminal can be assigned to display
caller identification for CAR incoming calls per CAR using this Memory Block.
0 1 / 4 9 : C A L L I D 0 O
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
CAR Port
No.