NEC Business Solutions Pty Ltd Xen Master & Xen Axis
1 - 516 PC Programming
A6-324000-642-02 - Release 5.0
May 2003
Verify
This option allows the technician to compare the configuration programmed in the
KTS with that of the PC.
First Initialisation
This option reinitialises the system to the factory-set defaults.
All active calls on the system are dropped.
Second Initialization
This option reboots the system without resetting the programmed defaults (i.e., all
programming is retained).
Setup
This option allows the technician to set up the system to provide communication.
Four options are available for this selection.
 PC Serial Port — serial port of the PC that is connected to the KTS.
 End User Password — the password programmed in Memory Block 1-8-
17 on the KTS.
 Site Name — the name of the site that is being programmed.
 Setup & Initialize — the KTS port settings/configurations.
Help
The Help pulldown menu allows access to online help.
Using Help
This option provides access to the help topics window that describes how to use
the help function.
Figure 3-11 Help Menu
To Next Page
Loading...
Need help?
General
