NEC Xen Master - 4-10 Station Number Assignment

1 - 332 Station Number Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0 May 2003
4-10
System Mode
4
Submode
—
Data No.
10
PC Programming
a
+BS
Station Number Assignment
General Description
Use this memory block to assign a station number to each telephone.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
AK to access the Memory Block.
3 Use dial pad to enter Setting Data for 2- (00
~99) , 3- (000~999), or
4-digit (0000
~9999) station number.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
Rto move to the next Tel No
Default Values
Valid Station Numbers are 100
~399.
4 After entering all data, press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-2-03
2-, 3-, or 4-Digit Station Number Selection
N
1. Station Number Assignment is per station. A station number cannot be assigned to more than one telephone. A
telephone cannot have more than one station number.
2. When changing Station Numbers to a different numbering plan perform the following steps in order.
a. Select Station Numbers using Memory Block 1-2-03 2-, 3-, or 4-Digit Station Number Selection.
b. Program applicable Access Code in Memory Block 1-1-46 Access Code (1-Digit) Assignment or 1-1-47
Access Code (2-Digit) Assignment.
c. Program all Station Numbers using this Memory Block.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 0 : S T A = 1 0 0
T I M E D I S P L A Y
Data
No.
Title
Tel Port
No.
(01~99)
A0~C0
Setting
Data
(00~9999)