NEC Xen Master - 6-2 Tenant Mode Copy Assignment

Tenant Mode Copy Assignment 1 - 395
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
6-2
System Mode
6
Submode
2
Data No.
—
Tenant Mode Copy Assignment
General Description
Use this Memory Block to enable copying data from one tenant to another tenant or multiple
consecutive tenants.
Example: To copy data of Tenant 00 to Tenant 05~07:
1. Enter the original Tenant No. Using the dial pad, press
KK.
2. Press
N.
3. Enter the beginning of the tenant (00~47) range to be copied to. Using the dial pad,
press
KE.
Display
Programming Procedures
1 Go off-line.
2 Press LK6 +
LK2 to access the Memory Block.
3 Enter the tenant to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
T N A T — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
T N A T 0 0 — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T N A T —
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T N A T 0 5 —
T I M E D I S P L A Y
Title
Setting
Data