1 - 336 CO/PBX Busy Forward Station Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
4-13
System Mode
4
Submode
—
Data No.
13
PC Programming
a
+ BTT
CO/PBX Busy Forward Station
Assignment
General Description
Use this Memory Block to specify up to two telephones to ring when a CO/PBX call
terminates at a busy station.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
ACto access the Memory Block.
3 Use dial pad to change data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Rto move to the next Tel Port No
Setting Data: Port No. 01 ~120
Default Values
Not specified
4 Press
Nto write the data for the first transfer to station.
5 Enter second transfer to station.
6 Press
Nto write the data.
7 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If the Multiline Terminal where the forward is initially set (Forward 1) is busy, the call is forwarded to a second
specified station (Forward 2).
2. If all three stations are busy, the first station rings.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 3 : F W D 1 =
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title
Forward
No. 1/2
To Next Page
Loading...
Need help?
General
