Programming Manual May 2003
Line Key Selection for Telephone Mode 1 - 335
A6-324000-642-02 - Release 6.0
May 2003
Function Table
Line Key
Functions
[For each telephone in tenant specified as
Telephone Mode in Memory Block 2-05
(Line Key Selection)]
Setting Data 1
LCD Indication
Setting Data 2
1 Not Specified NON N/A
2 CO/PBX line CO 01~64
3 Call Forward - Busy/No Answer FW BNA N/A
4 Call Forward - All Call FW ALL N/A
5 Call Appearance Block (00~47).
Refer to Note 6
C Call Appearance
Key
01~24
6 Feature Access FA 01~10
(01~16 if main
software is Release
4 and above)
7 Trunk Group TKGP 01~32
8 Route Advance ADV 01~16
9 Secondary Incoming Extension SIE Telephone Port No.
01~99
A0~C0
10 Microphone MIC N/A
11 Headset H SET N/A
12 Scroll Key for Caller ID SCROLL N/A
13 Do Not Disturb - Break Mode On/Off DND N/A
14 Log On/Off LOG N/A
15 Background Music On/Off BGM N/A
16 Intercom Key ICM N/A
N
1. If an Xen system is installed as a Key Function (KF) system, all COs must be assigned to the line keys. Trunk Groups,
Route Advance and Least Cost Routing (LCR) cannot be assigned.
2. At system default, line keys 09~24 are not assigned.
3. Telephone ports A0~C0 are ports 100~120.
To Next Page
Loading...
Need help?
General
