SLT or Automated Attendant/DISA to PBR Selection 1 - 191
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-8-01
System Mode
1
Submode
8
Data No.
01
PC Programming
a
+BTI
SLT or Automated Attendant/DISA
to PBR Selection
General Description
Use this Memory Block to specify whether the four Push Button Receiver (PBR) circuits in
the CPUB( )-U13 ETU/MBD-U13 Unit are used for Single Line Telephones or the
Automated Attendant/Direct Inward System Access (DISA).
Display
Settings
LK 1LK 2LK 3LK 4
There is no default setting.
PBR 1
and 2
PBR 3
and 4
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
KAto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
The LED indication changes to indicate the data each time the CO/PBX line key is pressed.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If LK1 and LK2 are assigned to Automated Attendant/DISA, the PBR( )--13 ETU must be installed in the system if
Single Line Telephones are used.
2. For Automated Attendant to function at least one PBR must be set.
0 1 : P B R ( S L T / A A )
T I M E D I S P L A Y
Data
No.
Title
CO/PBX
Line LED
Off On
Data
Single Line Telephone A.A./DISA
The shaded area indicates the default setting.
To Next Page
Loading...
Need help?
General
