1 - 344 SLT Hookflash Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
4-24
System Mode
4
Submode
—
Data No.
24
PC Programming
a
+BTI
SLT Hookflash Assignment
General Description
Use this memory block to specify the Single Line Telephone (SLT) hooking operation to
either Hold or disconnect the trunk.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Hold Disc
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK4 +
BD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
Rto go to next Tel Port No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-3-02
SLT Hookflash Signal Selection
4-23
Prime Line/Hot Line Assignment
N
1. This Memory Block affects only Single Line Telephone stations assigned Prime Line in Memory Block 4-23 Prime
Line/Hot Line Assignment.
2. When Prime Line is assigned to an Single Line Telephone, hookflash drops the CO and issues intercom (ICM) dial
tone if this Memory Block is set to disconnect.
3. After an SLT begins to dial out 9 +, hookflash follows Memory Block 1-3-02 SLT Hookflash Signal Selection
selection.
4. Telephone ports A0~C0 are ports 100~120.
0 1 / 2 4 : S L T H K H O L D
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title
To Next Page
Loading...
Need help?
General
