1 - 138 SLT Hookflash Signal Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-3-02
System Mode
1
Submode
3
Data No.
02
PC Programming
a
+BTI
SLT Hookflash Signal Selection
General Description
Use this Memory Block to specify whether a line is held internally, or if behind a PBX, a
hookflash (HF) signal is sent to the line when a Single Line Telephone user performs a
hookflash.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Hold Flash
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK3
+KBto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-02
Hookflash Time Selection
4-24
SLT Hookflash Assignment
N
1. If Hold is specified, the CO/PBX line is put on Exclusive Hold.
2. If Hold is selected, the PBX/CTX line can receive the hookflash signal via Access Code 6# (default).
3. If Flash is specified, press the hookswitch to send the hookflash signal to the PBX/CTX line.
0 2 : S I G N A L H 0 L D
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
To Next Page
Loading...
Need help?
General
