1 - 340 Station Name Assignment
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
4-18
System Mode
4
Submode
—
Data No.
18
PC Programming
a
+BTT
Station Name Assignment
General Description
Use this Memory Block to assign names for telephone stations.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
AH to access the Memory Block.
3 Use the dial pad to enter data. Refer to Section 7 Character Code Tables, and enter
the 3-digit code to display each character.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Uto clear all data when cursor is at setting data position
Rto go to next Tel Port No.
Default Values
Not Specified
4 Press
Nto write the data.
5 After entering all data, press
N
6 PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. While an internal line is ringing or in use, the station number and name of the other party are displayed.
2. The name is not displayed when Tone Override, Automatic Callback, or Callback Request is displayed
3. Only 6 digits/characters can be used for each name.
4. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 8 : < >
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
To Next Page
Loading...
Need help?
General
