NEC Xen Master - 4-58 Automated Attendant DID Assignment

Automated Attendant DID Assignment 1 - 377
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
4-58
System Mode
4
Submode
—
Data No.
58
PC Programming
a
+AU
Automated Attendant DID
Assignment
General Description
Use this Memory Block to determine the action after a DID call arrives at an extension or
CAR, and is not answered after predetermined time.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates the default setting.
NON AA1 AA2 AA3
LK 5 LK 6 LK 7 LK 8
AA4 AA5 AA6 AA7
Page 2
LK 9 LK 10 LK 11 LK 12
AA8
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1 Go off-line.
2 Press LK4 +
EHto access the Memory Block.
3 Press corresponding CO/PBX line key to change setting data 1.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
Rto move to the next Tel Port No
For example, to assign AA6, press LK7 to display.
Default Values
NON
4 Press
Nto write the data and display the next line key.
5 Repeat example and step 4 until all line key assignments are complete, and press
Nto enter last data.
6 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-4-02
Automated Attendant Transfer/DID Line - Delayed Ringing Time Selection
N
1. This Memory Block is applicable for main software Release 4.0 and above.
0 1 / 5 8 : D I D N ON / 1
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Page
No.
Setting
Data
Title