1 - 42 CO Transfer Ring Pattern Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-1-13
System Mode
1
Submode
1
Data No.
13
PC Programming
a
+BCS
CO Transfer Ring Pattern Selection
General Description
Use this Memory Block to select a Ring Pattern when CO transfers are made.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting
Tone Off Tone On Pattern A Pattern B
LK 5 LK 6 LK 7 LK 8
Pattern C Pattern D Pattern E Pattern F
(Page 2)
LK 1 LK 2 LK 3 LK 4
Pattern G Pattern H
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + AC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-14
CO Transfer Ring Tone Selection
1 3 : C O T P T N C | 1
T I M E D I S P L A Y
Data
No. Title
Setting
Data
Page
No.
To Next Page
Loading...
