Automated Attendant No Answer Disconnect Time Selection 1 - 151
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-4-03
System Mode
1
Submode
4
Data No.
03
PC Programming
a
+ AU
Automated Attendant No Answer
Disconnect Time Selection
General Description
Use this Memory Block to establish how long the Automated Attendant rings a station
before automatically disconnecting the caller.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
1 min. 2 min. 3 min. 4 min.
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
KCto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming
3-39
Automatic Release Selection
N
If the called party does not answer in the predetermined time, the call is dropped.
1. If Busy Tone Detector is enabled in Memory Block 3-39, then disconnection of an abandoned call during an
Automated Attendant message will be performed by the Trunk Card.
2. If Busy Tone Detector is not enabled, then Abandoned Call will continue to ring in the system for the duration of the
time set in Memory Block 1-4-03.
0 3 : A A D I S 2 m
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
Need help?
General
