ACR Digit Delete Assignment 1 - 251
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-14-05
System Mode
1
Submode
14
Data No.
05
PC Programming
a
+AO
ACR Digit Delete Assignment
General Description
Use this Memory Block to specify the number of digits to be deleted from the Route
assignment.
This feature requires System Software S3.XX or higher.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK14 +
LEto access the Memory Block.
3 Use dial pad keys
K~I to select Route No (01~32). and number of digits (00~10).
Note: Use
Jto move cursor left.
Use
Lto move cursor right.
If setting data is 00, digits are not deleted.
4 PressNto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03
Trunk-to-Trunk Group Assignment
4-41
LCR Class Selection
1-8-08
Class of Service (Station) Feature Selection 2
1-14-00
ACR Feature Allow/Deny Selection
1-14-01
ACR Dialling Assignment
1-14-01
ACR Dialled Number Dial Allow/Deny Selection
1-14-02
ACR Route Table Number Assignment
1-14-05
ACR Digit Add Assignment
1-14-03
ACR Trunk Group to Route Number Assignment
N
The maximum number of digits that can be deleted cannot exceed the number of digits used to route the call.
0 5 : D E L E T E 0 1 = 0 0
T I M E D I S P L A Y
Data
No.
Route
No.
Setting
Data
Title
To Next Page
Loading...
Need help?
General
