Doorphone Assignment 1 - 181
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
1-7-00
System Mode
1
Submode
7
Data No.
00
PC Programming
a
+BTP
Doorphone Assignment
General Description
Use this Memory Block to enable the doorphones in System Programming.
Display
Settings
LK 1LK 2LK 3LK 4
There is no default setting.
DP1 DP2 DP3 DP4
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK7 +
KK to access the Memory Block.
3 Press the CO/PBX line key corresponding to each doorphone. The LED changes to indicate the data each time the CO/PBX line
key is pressed.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-7-01
Doorphone Display Time Selection
0 0 : D P H A S S I G N
T I M E D I S P L A Y
Data
No.
Title
CO/PBX
Line LED
Off On
Data No Yes
There is no default setting.
To Next Page
Loading...
Need help?
General
