NEC Xen Master - 1-8-47 CAR for Voice Mail Message Notice Assignment

CAR for Voice Mail Message Notice Assignment 1 - 227
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
1-8-47
System Mode
1
Submode
8
Data No.
47
PC Programming
a
+AV
CAR for Voice Mail Message Notice
Assignment
General Description
Use this Memory Block to specify a CAR to indicate Voice Mail Message 9LED) set/cancel
on a remote Voice Mail system.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 +
DGto access the Memory Block.
3 Use the dial pad to enter data.
Note: Use the following to enter data:
A~H to enter Automated Attendant message number
Jto move the cursor LEFT
Jto move the cursor RIGHT
K~Ito enter numeric data
Press
Uto clear data at cursor.
KK~II,
KKK~III,
KKKK~IIII
Note: (Depends what length the extension number has been assigned in HB1-2-03.)
Default Values
Not assigned.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. This memory block is applicable to main software Release 4.0 and above.
4 7 : V M M S G C A R
T I M E D I S P L A Y
Data
No.
Setting
Data
Title