1 - 270 CO External Source Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
3-11
System Mode
3
Submode
—
Data No.
11
PC Programming
a
+BCT
CO External Source Selection
General Description
Use this Memory Block to specify which CO Trunk is to have an External Music Source
connected. A powered LIU must be used for Music Source Input. (Refer to System
Hardware Manual for details).
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
CO Ext Source
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + AAto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following when entering data:
R to go to the next CO/PBX Line No.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-12
CO Hold Melody Selection (CO)
N
1. This is also used for Tie lines.
1 1 / 1 1 : C O
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title