Prime Line/Hot Line Assignment 1 - 343
Programming Manual May 2003
A6-324000-642-02 - Release 6.0
May 2003
4-23
System Mode
4
Submode
—
Data No.
23
PC Programming
a
+BTT
Prime Line/Hot Line Assignment
General Description
Use this memory block to enable user to access various features when going off-hook.
Display
Programming Procedures
1 Go off-line.
2 Press LK4 +
BC to access the Memory Block.
3 Use dial pad to enter telephone number (10 Digits max.).
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Q+ J to input *
Q+ Jto input #
Default Values
Not Specified
4
Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Prime Line function enables a user to seize a specified trunk when the Multiline Terminal goes off-hook. Refer to
function codes 063 and 064 for Memory Blocks 1-1-46 Access Code (1-Digit) Assignment and 1-1-47 Access Code
(2-Digit) Assignment.
2. To call the specified station number or CO line on Hot Line, go off-hook.
3. When using Prime Line an access code (
T+ P) must be entered to seize the intercom (ICM) for internal
call processing.
4. To use Hot Line Assignment, one of the following must be entered:
• Station Number
• Access Code + Dial Number
• Speed Dial Access Code + Speed Dial Buffer Number.
5. Only 10 digits can be assigned.
6. Telephone ports A0~C0 are ports 100~120.
0 1 / 2 3 :
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting Data
To Next Page
Loading...
Need help?
General
