NEC Xen Master - 3-62 DIT Tenant Assignment

DIT Tenant Assignment 1 - 309
Programming Manual May 2003
A6-324000-642-02 - Release 6.0 May 2003
3-62
System Mode
3
Submode
—
Data No.
62
PC Programming
a
+BCT
DIT Tenant Assignment
General Description
This Memory Block is used to assign a CO/PBX Line to each tenant for incoming DIT calls.
Display
Programming Procedures
1 Go off-line.
2 Press LK3 +
N + DDto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Default Values
All CO/PBX Lines are set to tenant 00.
4 Press
Nto write the data.
5 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-09
Telephone to Tenant Assignment
0 1 / 6 2 : D I T = T N T 0 0
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Tenant No.
(00~47)