1 - 176 DSS Call Voice/Tone Signal Selection
NEC Business Solutions Ltd Xen Master & Xen Axis
A6-324000-642-02 - Release 6.0
May 2003
1-6-03
System Mode
1
Submode
6
Data No.
03
PC Programming
a
+BTD
DSS Call Voice/Tone Signal
Selection
General Description
Use this Memory Block to specify which is to be used first, Voice or Tone signaling, when
calling an extension from an Attendant Add-On Console.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates the default setting.
Tone Voice
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1 Go off-line.
2 Press LK1 + LK6
.
3 UseJto move cursor to the second Data No. position and pressCto access the Memory Block.
4 Press the corresponding CO/PBX line key to change the data option.
5 Press
Nto write the data.
6 Press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-6-01
Attendant Add-On Console to Telephone Port Assignment
N
1. Voice/tone signaling can also be switched by dialling 1 from a station.
2. If tone signaling is programmed in this Memory Block, the called party cannot answer handsfree unless the Direct
Station Select (DSS) station switches it to Voice by dialling 1.
0 3 : V O I C E C A L L
T I M E D I S P L A Y
Data
No.
Setting
Data
To Next Page
Loading...
Need help?
General
